CTS218 Compression and Tension Straps

The CTS218 is designed to repair wood members such as top plates, studs and trusses and is our first strap that handles both tension and compression loads. The unique rolled edges of the strap allow it to span gaps as wide as 4 1/2" and its 1 1/2" width enables installation on the narrow face of 2x lumber.

Tested specifically for top/bottom plate repair with various multi-strap configurations
Meets the requirements of the IBC and IRC for repairing top plates that have been cut or notched to accommodate plumbing or HVAC ductwork

Material: 14 gauge

Finish: Galvanized

Installation:

Use all specified fasteners. See General Notes.
One-sided installations – install one or two CTS straps on the same side of the member.
Two-sided installation – install CTS straps on opposite sides of member. For three-part installations, install two parts on one side, one part on opposite side.

Codes:

International Residential Code® - 2009 R602.6.1
International Building Code® - 2009 2308.9.8

These models are approved for installation with the Strong-Drive SD Structural-Connector screw.

Allowable loads have been increased for wind or seismic with no further increase allowed. Reduce where other loads govern.
Fastener quantities are for a single strap.
Maximum gap between wood members is 4 1/2".
FASTENERS: 10dx1 1/2 = 0.148" dia. x 1 1/2",
SD #9x1 1/2 = 0.131" dia. x 1 1/2" long.
See other nail sizes and information.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
CTS218		ESR-2105 / ESR-2523 *

* ESR-2523 is an Index of many of Simpson Strong-Tie Stamped and Welded Cold-formed Steel Products for Wood or Cold-formed Steel Construction

Download the Simpson Strong-Tie® AutoCAD® Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
CTS218	CTS218 front view: DWG \| DXF CTS218 left view: DWG \| DXF CTS218 top view: DWG \| DXF	CTS218 Installed: DWG \| DXF CTS218: DWG \| DXF