LTHJA26 Truss Hip/Jack Hangers

LTHJA26
U.S. Patent 7,913,472

Typical LTHJA26 Installation

Top View
Left Hand Hip Installation

Top View
Right Hand Hip Installation

Top View
Terminal Hip without Center Common Jack

The LTHJA26 is a lighter capacity version of the THJA26 and offers the lowest cost alternative for light hip/jack load applications.

Material: 18 gauge.

Finish: Galvanized. See Corrosion Information.

Installation:

Use all specified fasteners. See General Notes.
Shall be attached to a double girder truss to allow for required minimum nail penetration. See footnote 3.
10dx1 1/2" nails must be installed into bottom of hip members through bottom of hanger seat for table loads.

Options: These hangers can not be modified.

roll over images below to see larger image

Uplift loads have been increased 60% for wind or earthquake loading with no further increase allowed; reduce where other loads govern.
Wind (160) is a download rating.
Loads shown are based on a minimum 2-2x6 carrying member. For single 2x carrying members (min. 2x6), use 10dx1 1/2" nails and use 0.67 of the table value. For 2-2x4 carrying members, multiply the download by 0.50.
Tabulated hip and jack allowable loads assume that 75% of the total load is distributed to the hip and 25% to the jack. It is permitted to distribute 65% to 85% of the tabulated total load to the hip, and the remaining percentage of total load to the jack. The combined hip and jack load may not exceed the published Total Load.
Truss chord cross-grain tension may limit allowable loads in accordance with ANSI/TPI 1-2007. Simpson Strong-Tie® Connector Selector® software includes the ANSI/TPI evaluation in its hanger allowable loads. For additional information, contact Simpson Strong-Tie.
NAILS: 10d = 0.148" dia. x 3" long, 10dx1 1/2 = 0.148" dia. x 1 1/2" long. See other nail sizes and information.

* ESR-2523 is an Index of many of Simpson Strong-Tie Stamped and Welded Cold-formed Steel Products for Wood or Cold-formed Steel Construction

Download the Simpson Strong-Tie® AutoCAD® Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
LTHJA26	LTHJA26: DWG \| DXF LTHJA26 front view: DWG \| DXF LTHJA26 left view: DWG \| DXF LTHJA26 right view: DWG \| DXF LTHJA26 top view: DWG \| DXF	LTHJA26: DWG \| DXF