TSF Truss Spacer

Step 1
Nail starting notch to first member.

Step 2
As each successive member is positioned, unfold TSF to next notch. The notch teeth grip member and align it for nailing.

Step 3
If spacer does not align with end truss, break spacer off at notch. Then, hammer spacer flat, fold it under and nail.

The TSF is a fast and accurate method for spacing trusses that eliminates layout marking of top plates and can be left in place under the sheathing. Accuracy is improved, spacing errors are minimized, and it is easy to use.

Material: 24 gauge

Finish: Galvanized

Installation:

See Installation Sequence below.
TSF Truss Spacers do not provide bracing of any kind and are not structural members. The TSF is for spacing only. Refer to instructions from architect, engineer, truss manufacturer or other for bracing and installation information.

roll over images below to see larger image

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
TSF	See specific model numbers for code listings.
TSF2	No code listing. Please contact us for test data.
TSF2-16	No load capacity: Products not tested or submitted because they’re not load rated and code approval not required.
TSF2-24	No load capacity: Products not tested or submitted because they’re not load rated and code approval not required.

Download the Simpson Strong-Tie® AutoCAD® Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
TSF	None for this model	TSF View 1: DWG \| DXF TSF View 2: DWG \| DXF TSF View 3: DWG \| DXF
TSF2	None for this model	None for this model
TSF2-16	TSF2-16: DWG \| DXF TSF2-16 front view: DWG \| DXF TSF2-16 right view: DWG \| DXF TSF2-16 top view: DWG \| DXF	None for this model
TSF2-24	TSF2-24: DWG \| DXF TSF2-24 front view: DWG \| DXF TSF2-24 right view: DWG \| DXF TSF2-24 top view: DWG \| DXF	None for this model