WM/WMI/WMU Hangers for Masonry and Concrete

See Top Flange Hanger Tables for sizes, fasteners and load information.

WMs are designed for use on standard 8" grouted masonry block wall construction.

Material: See Top Flange Hanger Tables for sizes, fasteners and load information; WM, WMI, WMU—12 ga. top flange and stirrup

Finish: Simpson Strong-Tie® gray paint; hot-dipped galvanized available: specify HDG.

Installation:

Use all specified fasteners.
WM - two 16d duplex nails must be installed into the top flange and embedded into the grouted wall. Verify that the grouted wall can take the required fasteners specified in the table.
Mid-Wall Installation: Installed between blocks with duplex nails cast into grout with a minimum of one grouted course above and below the top flange and one #5 vertical rebar minimum 24" long in each adjacent cell.
Top Of Wall Installation: Install on top of wall to a grouted beam with masonry screws.
Refer to T-SLOPEJST for information regarding load reductions on selected hangers which can be
used without modification to support joists which have shallow slopes (3/4:12).

Options:

See Top Flange Hanger Tables for sizes, fasteners and load information.

Uplift loads have been increase for wind or earthquake loading with no further increase allowed. Reduce where other loads govern.
See figures for Top-of-Wall and Mid-Wall installation. Minimum f'_m = 1500 psi.
Products shall be installed such that the Titen® screws are not exposed to weather.
For hanger heights that exceed the joist height, the allowable load is 0.50 of the table load.
NAILS: 16d DPLX = 0.162" dia. x 3 1/2" long, 10dx1 1/2 = 0.148" dia. x 1 1/2" long. See other nail sizes and information.

					Legacy Reports
	IAPMO ES ER	ICC-ES ESR	CITY OF LOS ANGELES	STATE OF FLORIDA	ICC-ES NER	ICC-ES ER	ICC-ES ES
WM	No code listing. Please contact us for test data.
WMI	No code listing. Please contact us for test data.
WMU	No code listing. Please contact us for test data.

* ESR-2523 is an Index of many of Simpson Strong-Tie Stamped and Welded Cold-formed Steel Products for Wood or Cold-formed Steel Construction

Download the Simpson Strong-Tie® AutoCAD® Menu, which allows you to insert Ortho views directly into your AutoCAD drawing.

	ORTHOGRAPHIC	PERSPECTIVE
WM	None for this model	WM View 1: DWG \| DXF WM View 2: DWG \| DXF WM Skewed: DWG \| DXF
WMI	None for this model	None for this model
WMU	None for this model	None for this model